a. Keep the battery clean, wipe the spilled electrolyte, contaminated soil and dust, etc .; poles and wiring chucks should be cleaned and exposed to good, and is good contact, and to prevent oxidation; the vent hole on the battery cover To remain smooth and prevent dirt from clogging.B. When the battery is stored, the battery is replaced, and then the engine is started. It is forbidden to blend the battery and sufficient electric storage battery, which not only affects the battery life and is not conducive to the start of the engine.
C. Email short circuit to prevent damage to the battery. When the battery is disassembled, it is necessary to avoid the object such as a tool, such as the battery, etc. wrap up.
D. Regularly check the liquid level height of the battery electrolyte liquid, so that it remains within the predetermined range indicated by the battery case, avoiding the life of the battery due to insufficient electrolyte. Inspection period is generally controlled in: every half a month of winter, check once a week. When the liquid level is found, distilled water should be added in time. Here, it is to be noted that when the electrolytic solution is found, it should be noted that the electrolyte leakage is caused by damage or other reasons for battery housing, or normal loss to take appropriate measures.
E. To keep the battery to save electricity, it cannot be charged frequently. In general, the amount of storage can be estimated according to the volume of the speaker, and the electrolyte density can also be calculated or used by the electrolyte density to check the storage of the battery, and it is found that the power is insufficient to be charged. If the battery is in a loss, it is easy to cause a plate oxidation, and shorten the battery life of the battery.
F. The battery is not used to place it on the shelf while avoiding directly in the ground. Clean the outside of the battery before storage, add the electrolyte, sufficient electricity, and tighten the screw. A complementary charge is carried out every other month later, and the height of the electrolyte liquid level is checked every half month, and then add it immediately. If it is stored in winter, pay attention to antifreeze.
There is enough oil pressure to start oil. At the same time, the wear leakage of the inclined surface is stopped, so that the plunger stops the oil supply before the oil supply termination position. Therefore, the worn of the plunger dolls after wear will be shorter than normal. Recommend: LiFePO4 Battery Manufacturer Energy storage battery Manufacturer Integrated machine energy storage battery series Manufacturer Lead lithium battery Manufacturer Outdoor Backup Battery Manufacturer Portable outdoor power supply Manufacturer Power battery Manufacturer Powerwall LiFePO4 Battery Manufacturer Battery rack Manufacturers Telecom LiFePO4 Battery Manufacturer Wall mounted battery storage Manufacturer China Lifepo4 Battery
