1. The battery is not used for a long time, it will slowly discharge it until it is scrapped. Therefore, a car should be started every other period of time to charge the battery. Another way is to pull the two electrodes on the battery, it should be noted that the positive and negative two electrode lines are unplugged from the electrode column. The negative electrode line is unplugged, or remove the negative electrode and the car chassis, then Pulling the other end with the positive log (10). The battery has a certain service life to replace it in a certain period of time. In the case of replacement, the above order is also followed, but when the electrode line is connected, the order is exactly the opposite, first pick the positive electrode, and then connect the negative electrode.2. The storage capacity of the battery can be reflected on the dashboard. When the current table pointer does not display insufficient storage, it should be charged in time. Sometimes the amount of power is not enough during the road, the engine is turned off, and as temporary measures can be used to help other vehicles, the vehicle is used to start the vehicle, and the negative electrode and the negative electrode of the two batteries are connected. .
3. The density of the electrolyte should be adjusted according to the standard according to the standards in different regions.
4. Distilled water or special replenishment should be supplemented during loss of electrolyte, avoiding drinking pure water instead, because pure water contains a variety of trace elements, causing adverse effects on the battery.
5. When starting the car, the starter is not intermittently used to cause the battery to be damaged due to excessive discharge. The correct way to use is that each time the launch has a total length of no more than 5 seconds, and the startup time is not less than 15 seconds. Reasons should be found in other (tortures) of circuits, ignition coils or oils in the case of multiple launches.
6. In the daily driving, it should be checked whether the small hole on the battery cover is ventilated. If the battery cover small hole is blocked, the resulting hydrogen and oxygen rins do not go out, and the electrolyte is expanded, and the battery housing is broken, affecting the battery life.
7. Check the positive and negative electrode without oxidation of the battery, and can use hot water to grow the electric wire of the battery.
8. Check the part of the circuit has no aging or short circuit, prevent the battery from retiring because of over-discharging Recommend: LiFePO4 Battery Manufacturer Energy storage battery Manufacturer Integrated machine energy storage battery series Manufacturer Lead lithium battery Manufacturer Outdoor Backup Battery Manufacturer Portable outdoor power supply Manufacturer Power battery Manufacturer Powerwall LiFePO4 Battery Manufacturer Battery rack Manufacturers Telecom LiFePO4 Battery Manufacturer Wall mounted battery storage Manufacturer China Lifepo4 Battery
