After the positive electrode is completed, the plate is removed from the chemical groove, and can be placed directly to the polar plate, and can also be shipped to the designated position with the card or container, and some process require water washing, and then place it in the plate holder On; the battery has a direct protocol on the polar plate, and the spacing between the plates is 1-5 mm, and then it is pulled. After that, the polar plate is released, and the dry kiln has a heating device. The general heat source is steam or electricity, and there is a circulating wind system inside, and there is a humidification system outside. The placement of the polar plate is the same as the wind direction of the circulating wind of the dry kiln, and the battery is the interval between the circulating wind through the polar plate, and the plate is dried.The drying temperature of the dried kiln is 80-90 to c, and the temperature can cause thermivolivization of the positive electrode plate, in particular the dry load electrode plate, must avoid thermivolivization. --dry time is 20h, daily - ¡¤ a cycle. Set the circulating wind and the rhinar parameters depending on the device. The positive plate is dry to pay attention to the warming and cooling. Avoid disasterless drying due to some parts of dry kiln, and there are uniformly and dryness of certain parts of the battery.
Article from: http://www.brcpower.com Recommend: LiFePO4 Battery Manufacturer Energy storage battery Manufacturer Integrated machine energy storage battery series Manufacturer Lead lithium battery Manufacturer Outdoor Backup Battery Manufacturer Portable outdoor power supply Manufacturer Power battery Manufacturer Powerwall LiFePO4 Battery Manufacturer Battery rack Manufacturers Telecom LiFePO4 Battery Manufacturer Wall mounted battery storage Manufacturer China Lifepo4 Battery
