The electric forklift is used as an engineering vehicle based on the battery as a power source. It will definitely cause dust to other parts of the combined forklift during use. The running system of the forklift is connected by many components, working together, maintains the normal operation of the forklift, and too much dust can cause the components to block, affect the operation of each system of the forklift, and the slight fault indication leads to the operation problem. It may cause engineering accidents. Therefore, we should perform regular cleaning of components of the combined forklift. Some wear parts can be replaced at the same time.For the cleaning of some metal parts of the forklift, we usually use two cold cleaning and hot washing. The so-called cold cleaning method is to dry with kerosene, quickly, diesel oil or gasoline cleaning, was blown with compressed air. This method of equipment is required for this cleaning method and fast operation. The hot washing is cleaned with an alkali solution, and the solution is heated, and the part is extracted, and the base solution is rinsed with water, and then dried with compressed air. To prevent aluminum alloy parts from being corroded, it is not possible to clean with a solution containing a large number of caustic sodium.
For the cleaning sealing ring of some non-metallic forklift accessories on the forklift, the cleaning of alcohol, rubber parts, such as brake pads, turpentine or brake fluid cleaning. Do not wash the kerosene, rubber ring, hydraulic gasoline or alkali solution to prevent swelling deterioration. The clutch friction sheet and the brake friction film cannot be cooked with a base solution, and a little gasoline brush is applied. Cortical parts (such as oil seal, etc.) generally use the dry cloth to wipe it.
There is also a black solid on the soiled of the forklift parts, which is gradually formed in high temperature and high pressure, firmly attached to the surface of the internal combustion engine piston, cylinder line, cylinder head, and the texture is extremely hard. In repair, the carbon carbon is required, or to ensure that the forklift can operate normally, it must also regularly clear the carbonide on the machine. This soil usually use two methods to clean, one is physically cleaned, that is, scrapes with a blade, a blade (or bamboo sheet), metal brush. This efficiency is low in hand-cleared carbon deposits, and it is difficult to remove clean. If there is any accident, the part will be damaged. The second is to remove the carbon fluid by chemical methods. Clear internal combustion engine parts carbon bank formula: then soak the parts carbon deposits in the cleaning solution, if there is a heating device optimal, so it can be easily softened, etc. After soaking, it can easily peel the solid dirt.
The electric forklift battery can be rinsed with water, but the water cannot enter the battery cell. It is best to hang out to rinse and avoid the forklift part of the components into water. The forklift battery uses a certain period of time, which produces a resistance between the oxide, and the battery monomer, and it is necessary to clean.
In short, in daily work, more maintenance can make the electric forklift for a longer period of time and reduce the loss of the forklift. Recommend: LiFePO4 Battery Manufacturer Energy storage battery Manufacturer Integrated machine energy storage battery series Manufacturer Lead lithium battery Manufacturer Outdoor Backup Battery Manufacturer Portable outdoor power supply Manufacturer Power battery Manufacturer Powerwall LiFePO4 Battery Manufacturer Battery rack Manufacturers Telecom LiFePO4 Battery Manufacturer Wall mounted battery storage Manufacturer China Lifepo4 Battery
