Battery safety instructionsFirst, daily inspection
1, liquid plane
Lower than rated liquid, will shorten the battery life of the battery, and the electrolyte is too small to cause heat storage, so it must be noted that the electrolyte is sufficient.
2, terminal column, wire, cover
The battery terminal joint must be often checked, and the connection caused by oxidation due to oxidation, while checking whether the lid is deformed due to oxidation.
3, appearance
The battery surface is dirty will cause leakage, which should make the battery surface clean and dry.
Second, maintenance
1, add water
Add distilled water at a specified liquid surface, do not add excessive distilled water to extend the water space interval, and the water is overproduced, resulting in leakage.
2, charging
During the charging process, the battery will generate a gas, and should keep the charging site well, there is no open flame around the charging, and the oxygen generated during the charging process will affect the surroundings.
Exploring the charging plug during charging will generate an arc, and the plug can be unplugged after the charger is closed.
After charging, many hydrogen are left around the battery, and there is no open flame, which should open the cover on the battery for charging.
3, wiring column, wire, cover repair
The professional technicians specified by the manufacturer can be performed.
4, clean
If it is not too dirty, it can be wiped with wet cloth. If it is very dirty, it is necessary to remove the battery from the car and clean it naturally.
Third, keeping
1, storage place
Can't make it short;
Due to rain, short circuits may produce fires, and may produce a small amount of hydrogen, so the battery must be stored in a ventilated and cool place.
2, waste battery
Waste batteries still have electrical energy, and should be kept in accordance with the battery storage method used.
Fourth, the operation of the electrolyte
1, check the proportion
Use the suction specific gravity to check the specific gravity, do not let the electrolyte are splashed out while homework and wear protective tools.
2, in addition to the operation
Advise the professional consultation, especially when supplementary electrolyte (dilute sulfate).
3, electrolyte leakage
Due to the tipping of the battery, the damage causes the electrolyte leak, emergency treatment should be carried out (refer to emergency items)
Five, life life ending battery operation
1, life life of the battery
When the battery is close to the life, the electrolyte in a single battery will decrease and supplement distilled water every day.
2. Treatment of waste batteries
For useful batteries, the electrolyte is extracted, and the battery is decomposed. Can negotiate if it is recycled by a battery manufacturer.
Sixth, emergency treatment
1, electrolytic solution splash to the skin
Rinse with a lot of water
2, the electrolyte splashed to the eyes
Rinse with a lot of water, then accept the treatment of professional doctors
3, electrolyte splash to clothes
Under the clothes immediately, rinse with a weak alkaline soap with water.
4, electrolyte leakage
When the electrolyte is disclosed to the outside, it immediately uses lime, strong carbonate or carbonated soda, and is built with a large amount of water.
1. Check before charging: Whether the battery is intact, whether the wiring is intact, and open the air cover.
Do not open or dial the liquid plug on the battery
Do not add liquid before charging or charging
Smoking is strictly prohibited near the battery, generating sparks or open flames
When charging, the battery cannot discharge at the same time.
Do not put the metal tool on the battery when charging
Do not repair battery when charging
When charging is charged, the electrolyte temperature is below 55 ¡ã C.
2, if the new battery is cooled to the electrolyte of 1.26 to 30 ¡ã C, the battery is injected into the battery, and the injection amount is higher than the protective plate 10 to 20 mm, waiting for 6 hours, the liquid temperature dropped below 35 ¡ã C. Start charging. The electrolyte specific gravity is 10 ¡ã C, and the different temperature should be converted according to the following formula: D30 ¡ã C = DT + 0.007 (T-30 ¡ã C)
3
4, when the battery is charged to saturation, the voltage and electrolyte is basically not rising within 2 to 3 hours, and a large amount of air bubbles, the electrolyte is more than 1.26, and the single voltage is 2.4V.
5. When the single voltage dropped to 1.7V, the voltage meter voltage 41V (driving load), the electrolysis specific gravity decreases to 1.18, should be charged in time.
6. When charging battery charging, the electrolyte specific gravity is 1.26 with distilled water or a specific gravity of 1.4, and the electrolyte specific gravity is 1.26 and maintains a sufficient height. Battery charging start ends should be recorded for voltage electrolyte. Record will help the maintenance and protection analysis of the battery.
7. Do not near the fire and heat sources. After the charging is completed, the gas cover is covered, and the electrolyte is wiped out, keep the joint clean and dry, and apply Vaseline. Battery flushing must be carried out outside the car.
8. The battery charging environment must be well ventilated. Especially with the car is charged around the air. The battery charger has a good ventilation device, and the temperature is not higher than 40 ¡ã C, and the air flow can be calculated to avoid the accumulation of hydrogen-oxygen mixed gas during battery charging. The following formula can be calculated: q = 0.05 ¡Á I ¡Á n (where Q : Air flow, I: Charging the final charging current, N: Battery monomer), should ensure that the air flow between the charging is greater than the amount of air flow in the calculation formula.
9, the beginning of the battery, often charged data can be refer to the table below, (such as the battery belt manual, please follow the instructions)
Elementary charging often charge
I II I II
Current (A) Time (H) Current (A) Time (H) Current (A) Time (H) Current (a) Time (H)
45 35-45 26 35-50 62 4-6 31 6-10
The charging time of the first phase I can be grasped by charging characteristics. When the battery voltage rises above 2.4V, it can be changed to the stage II stage.
Note: Can be equipped with an automatic charger, the charging program will automatically charge the battery without overcharge and the inclusion of the charge.
Battery safety instructions
First, daily inspection
1, liquid plane
Lower than rated liquid, will shorten the battery life of the battery, and the electrolyte is too small to cause heat storage, so it must be noted that the electrolyte is sufficient.
2, terminal column, wire, cover
The battery terminal joint must be often checked, and the connection caused by oxidation due to oxidation, while checking whether the lid is deformed due to oxidation.
3, appearance
The battery surface is dirty will cause leakage, which should make the battery surface clean and dry.
Second, maintenance
1, add water
Add distilled water at a specified liquid surface, do not add excessive distilled water to extend the water space interval, and the water is overproduced, resulting in leakage.
2, charging
During the charging process, the battery will generate a gas, and should keep the charging site well, there is no open flame around the charging, and the oxygen generated during the charging process will affect the surroundings.
Exploring the charging plug during charging will generate an arc, and the plug can be unplugged after the charger is closed.
After charging, many hydrogen are left around the battery, and there is no open flame, which should open the cover on the battery for charging.
3, wiring column, wire, cover repair
The professional technicians specified by the manufacturer can be performed.
4, clean
If it is not too dirty, it can be wiped with wet cloth. If it is very dirty, it is necessary to remove the battery from the car and clean it naturally.
Third, keeping
1, storage place
Can't make it short;
Due to rain, short circuits may produce fires, and may produce a small amount of hydrogen, so the battery must be stored in a ventilated and cool place.
2, waste battery
Waste batteries still have electrical energy, and should be kept in accordance with the battery storage method used.
Fourth, the operation of the electrolyte
1, check the proportion
Use the suction specific gravity to check the specific gravity, do not let the electrolyte are splashed out while homework and wear protective tools.
2, in addition to the operation
Advise the professional consultation, especially when supplementary electrolyte (dilute sulfate).
3, electrolyte leakage
Due to the tipping of the battery, the damage causes the electrolyte leak, emergency treatment should be carried out (refer to emergency items)
Five, life life ending battery operation
1, life life of the battery
When the battery is close to the life, the electrolyte in a single battery will decrease and supplement distilled water every day.
2. Treatment of waste batteries
For useful batteries, the electrolyte is extracted, and the battery is decomposed. Can negotiate if it is recycled by a battery manufacturer.
Sixth, emergency treatment
1, electrolytic solution splash to the skin
Rinse with a lot of water
2, the electrolyte splashed to the eyes
Rinse with a lot of water, then accept the treatment of professional doctors
3, electrolyte splash to clothes
Under the clothes immediately, rinse with a weak alkaline soap with water.
4, electrolyte leakage
When the electrolyte is disclosed to the outside, it immediately uses lime, strong carbonate or carbonated soda, and is built with a large amount of water.
Article from: http://www.brcp Recommend: LiFePO4 Battery Manufacturer Energy storage battery Manufacturer Integrated machine energy storage battery series Manufacturer Lead lithium battery Manufacturer Outdoor Backup Battery Manufacturer Portable outdoor power supply Manufacturer Power battery Manufacturer Powerwall LiFePO4 Battery Manufacturer Battery rack Manufacturers Telecom LiFePO4 Battery Manufacturer Wall mounted battery storage Manufacturer China Lifepo4 Battery
