1, polar pile and collet size do not match. When the installation is too loose, since the current is too large, the contact surface is too small or the contact is poor, it is easy to burn the pole column; the installation is too tight, the mammoth is smashed, and it is easy to damage the pole, causing the battery to scrap.2, unreliable fixation, the vehicle produces severe vibration in travel, calendering the enamel, housing and cover.
3, the charging current is too large, causing the active substance on the plates to fall out, shorten the battery life.
4, the starting time is too long, so that the battery is dramatically discharged, resulting in a polar bending, the active material cracking.
5. Long-term placement or use in the absence of insufficient charging, vulcanizing the plate.
6, the electrolytic liquid surface is lower than the plate, which causes the electrode plate to expose the liquid surface and is exposed to air. During driving, the electrolyte is fluctuated up and down, and contacts the oxidizing moiety of the plate, resulting in a plate vulcanization.
7, the electrolyte contains impurities, mainly for distilled water and the metal container such as copper and iron when the electrolytic solution is formulated. These impurities will form in the battery“Small circuit”To allow the battery to accelerate its own discharge.
8, wiping and maintenance is not in time, the overflowing electrolyte is deposited on the cover, resulting in a polar pile and causing corrosion, producing an oxide, thereby forming a passage on the cover, and there is a self-discharge phenomenon.
9, the new battery does not perform initial charging or direct large current charging, will also shorten its service life. The new car battery can be installed after the end of the electrolyte and the method of small current must be used.
10, ignore the venting hole of the battery, if it is not turned on, the gas generated in the use cannot be discharged, and the battery will explode due to high pressure.
11. When the battery is added to distilled water, it is long and not charged, causing the battery self-discharge or damaging the polarity of the battery.
12. The charge capacity of the battery does not match the engine, resulting in early damage to the plate. Recommend: LiFePO4 Battery Manufacturer Energy storage battery Manufacturer Integrated machine energy storage battery series Manufacturer Lead lithium battery Manufacturer Outdoor Backup Battery Manufacturer Portable outdoor power supply Manufacturer Power battery Manufacturer Powerwall LiFePO4 Battery Manufacturer Battery rack Manufacturers Telecom LiFePO4 Battery Manufacturer Wall mounted battery storage Manufacturer China Lifepo4 Battery
